GU Centre Console Removal
Submitted: Tuesday, May 01, 2007 at 13:48
ThreadID:
44966
Views:
2704
Replies:
3
FollowUps:
2
This Thread has been Archived
Member - Craig D (SA)
Hi all,
anyone know how to remove the centre console from a GU? The bit I need to remove is the storage part back from the ashtray. I can remove all the screws but I can't seem to get the captive clips to let go where the rear of the console joins into the section for the ashtray and gear boots. What's also making it difficult is that access is restricted because it's a Cab Chassis and I can't get in "the back" to give it a good heave-ho :)))(
Any help appreciated (?).
Regards,
Reply By: Gimp35 - Tuesday, May 01, 2007 at 14:31
Tuesday, May 01, 2007 at 14:31
Hi Craig,
I think you need to remove the front section first, that's the part that goes over the gear levers.
Remove the gear knobs first, then the ash tray and the screw bellow it and the 2 screws either side closer to the dash. Now lift from the ash tray end first and this front section should come off.
Now you can try and remove the rear section.
Paul
AnswerID:
237123
Follow Up By: Member - Craig D (SA) - Tuesday, May 01, 2007 at 14:45
Tuesday, May 01, 2007 at 14:45
Cheers Paul....I'll give everything a go!
FollowupID:
498145