Resetting Rodeo 4WD system
Submitted: Tuesday, Mar 04, 2008 at 15:07
ThreadID:
55174
Views:
4068
Replies:
2
FollowUps:
1
This Thread has been Archived
Nic I (NSW)
A mere 2,400km into the life of my 07 Rodeo TD 4WD, I used 4L for about 2km of medium-steep/slippery track. After stopping and selecting 2WD the '
Check 4WD' light appeared, meaning I was stuck in 2WD for the rest of that trip. Luckily I was able to complete the trip in 2WD without incident.
The dealer blamed me for 'not following the instructions in the manual' (utter codswallop), 'fixed' it, and very reluctantly gave me a scribbled set of instructions on resetting the system, which I've included below.
When I suggested that these instructions should be included in the manual, the response was 'not necessary if owners use the system correctly'. More cods.
Here's how to reset it:
1. Ignition off, hold all 3 buttons (2H, 4H & 4L) in together
2. Switch ignition on to 'reds' position (last position before start)
3. Hold in this state for 30 seconds
Hope this may be of use !!
NicI