100 series Back seats
Submitted: Wednesday, Sep 10, 2003 at 20:48
ThreadID:
7156
Views:
1376
Replies:
1
FollowUps:
2
This Thread has been Archived
bob_h (Brisbane)
Can anyone give me some pointers on removing the back seats (second row, not third) to make some more luggage space. The brackets are covered by plastic and I can't see any way of removing these covers without damage. TIA
Reply By: Barry - Wednesday, Sep 10, 2003 at 21:47
Wednesday, Sep 10, 2003 at 21:47
The plastic covers are snapped on. A bit of careful coaxing gets them off again.
They are held on by a tab on each side, between the two slots.
I removed
mine OK without damage, then built a flat floor for the second row area and bolted this down to the second row
seat mounts via the rearmost of the two bolts on each outboard bracket.
Barry
AnswerID:
30726
Follow Up By: Barry - Saturday, Sep 13, 2003 at 16:14
Saturday, Sep 13, 2003 at 16:14
Sorry Bob,
I gave instructions for the plastic covers on the FRONT seats.
For the REAR, they are also held on by a tab on each side - just slip your fingers underneath at the front corners and lift outwards slightly.
Barry
FollowupID:
21936
Follow Up By: Barry - Saturday, Sep 13, 2003 at 16:15
Saturday, Sep 13, 2003 at 16:15
That is, with the middle seats folded forward into the storage position.
Barry
FollowupID:
21938