Comment: Toyota Wheel Studs - Replacing the standard 78/79 series studs with cus
Submitted: Monday, Aug 01, 2011 at 16:32
ThreadID:
113744
Views:
2013
Replies:
1
FollowUps:
0
This Thread has been Archived
MUZBRY- Life member(Vic)
Gday Mick
Just looking again. I see that you have made the stud shoulder the same size as the disc holes. That should take slack from the disc rotating on the axle when brakes are applied and excelerating . That should fix the elongation in the wheel stud holes .Good one Mick. We better have a look in
Silverton .
Reply By: Mick O - Wednesday, Mar 04, 2015 at 01:07
Wednesday, Mar 04, 2015 at 01:07
There is actually about a millimetre of space overall 0.5 per side. The shoulder now extends to the edge of the outer edge of the disk rotor eliminating that shear point. I'll bring a few along to show you. Looking forward to the catch-up.
Cheers. Mick
AnswerID:
548021