80 Series LC Servicing front axle
Submitted: Tuesday, Jun 08, 2004 at 13:39
ThreadID:
13585
Views:
1993
Replies:
3
FollowUps:
1
This Thread has been Archived
Twigiee
I'm planning on servicing the front axle on my 80 Series TD GXL Landcruiser. I've got the bearing kit from CBC with bearings, inner axle seals, knuckle wipe seals etc. I've got lots of experience from repairing and rebuilding 2wd conventional vehicles, but never tackled a 4wd before. I'm wondering whether there are any 'tricks of the trade', or special toyota
tools that may be required to do this.
Twigiee
Reply By: Bob Y. - Qld - Tuesday, Jun 08, 2004 at 14:20
Tuesday, Jun 08, 2004 at 14:20
Twigiee,
Don't need any special tools, list of a few here:
Socket to suit hub nuts(about 52 or 56mm),
Copper hammer,
Circlip pliers-outer,
Bearing packer,
Assorted sockets, rings & open-end spanners.
Plenty of rags, hand towels & HAND CLEANER.
Recommend the 80's cool site, as suggested above, the article is as good as a w'
shop manual.
Hooroo...
AnswerID:
62248