Front Recovery Point for Prado 120

I fitted a pair of the recovery points indicated on the LCOOL site. The instructions/photos provided were good and installation was easy (had to buy the high-tensile nuts/bolts separately though). if you didn't want to do it yourself any handyman or auto mech could do it .. it is not a specialist job

Can't remember how I found this out but I purchased them from a David Sheridan at CMI Toyota in SA ( Ph. 08 82385530 Mobile 0418 820349 dsheridan@cmv.com.au). About $100pr I think

David sells the hooks, as well as I do, and you need spacers and a slight mod to the washer bottle protector plate if you have an ARB bar, and if you have a factory alloy bar, I also do a protector plate for the radiator, and the hooks just need a hole re sized, and bolts to mount them.

Have just finished our slider steps for the 120, the ifs 100, and the 90, and the 90 rear bar is also completed, working on the jerry holder now, starting the 120 rear bar next week.

hooks can be seen in pic 2 on the link.

plates and hooks