Fishing rod holders

Submitted: Wednesday, Oct 05, 2005 at 20:05
ThreadID: 27011 Views:3180 Replies:4 FollowUps:1
This Thread has been Archived
Can anyone please tell me what states bullbar mounted fishing rod holders are legal in, if any?
Back Expand Un-Read 0 Moderator

Reply By: Brian B (QLD) - Wednesday, Oct 05, 2005 at 20:15

Wednesday, Oct 05, 2005 at 20:15
Hi,

In Queensland they must be mounted only to the left side of the bullbar and can only have a capacity to carry four rods and vehicle lighting and the drivers view of the road must not be obstructed by the rods or the holder. Rod holders must be either removed or retracted to behind the profile of the bullbar when not in use.

Source of information - QLD Government All About Modifications to Vehicles Web Site.

Hope this helps.
AnswerID: 133168

Reply By: revhead307 - Wednesday, Oct 05, 2005 at 20:15

Wednesday, Oct 05, 2005 at 20:15
In WA they are not allowed to protrude infront of the bullbar and there is also a rule on what angle u can have it at (i cant remember)

ive driven round for years with a rod holder on the front....and sadly...its got to the stage where i've taken it off...

Cops over here have been giving out $100 fines...and even yellow stickers to members of the local fishing club.

In reality, i never used mine anyway...not a good way to look after your precious rods. Mine are now on the roof.

Rev
AnswerID: 133170

Reply By: Sand Man (SA) - Thursday, Oct 06, 2005 at 03:17

Thursday, Oct 06, 2005 at 03:17
I always thought that these rod holders are a bit of a wank, except perhaps during a trip along the beach.

I value my collection of rods and like to look after them.
On a typical fishing trip, I would normally take four. Two for me and two for my bride. When fishing, one of each is rigged for bottom fishing and the other two with floats for the top.

Now I prefer a one piece rod of about 6' - 6'6" and as I usually use fresh tackle (hooks and their traces) each trip, I find no problem in rigging them up at the start and disconnecting the tackle at the end.

I carry the rods in a 100mm diameter piece of PVC pressure pipe about 2150mm long (about 7') with purpose designed, reinforced caps at each end and attached to the roof racks. This keeps the Rods protected from dirt and the "elements" and provides good mechanical protection as well. The end caps are also lockable which provides better security than most other methods of rod storage.

I also have a couple of baitcaster rods, a fly rod and a surf rod (two piece), all of which will physically fit inside the pipe if necessary. The reels are carried and stored separately in a backpack, along with the fishing traces/rigs, etc.

So again, I would question the need for "rocket launchers" attached to Bull Bars, but of course this is only my opinion and the setup that best works for me.
Bill


I'm diagonally parked in a parallel Universe!

Member
My Profile  My Blog  My Position  Send Message

AnswerID: 133219

Follow Up By: datto311 - Thursday, Oct 06, 2005 at 19:02

Thursday, Oct 06, 2005 at 19:02
Here in Queensland where we use 13-14 foot surf rods with Alvey sde cast reels, "rocket launchers" are really the only way to carry these rods, especially when we may visit a dozen or more gutters during a normal fishing day . Chasing fish in the surf on our beaches means you are on the go all the time

However once the trip is over these should come off straight away. Just imagine the horrific pedestrian injuries....
0
FollowupID: 387523

Reply By: Member - Athol (NSW) - Thursday, Oct 06, 2005 at 19:07

Thursday, Oct 06, 2005 at 19:07
Beltman,
it's a $225 and 3 points from your licence for any protrustions from a bullbar in NSW.

Athol
AnswerID: 133318

Sponsored Links