Monday, Nov 20, 2006 at 22:29
Ok boys here's the good guff.
Fit the stove by drilling 4 holes (1/4") in the centre of the raised up bits on the bottom of the stove.
Position the stove fully open (but disembled of the guts) as if you were going to
cook and mark the holes on the timber stove base of the kitchen
Make sure some clearance at back and that you are (with a bit of jiggling) able to fold out wind shields and fit into position. Once all the holes are drilled use
TANK BOLTS (because they are nice and low profile) bolts from the underside up into the stove. Use supaglue, fingernail polish etc to "lock" the nuts so they do not come loose.
Next day mark where the regulator that fits into the side of the stove needs to go and using a hole saw carefully drill a new hole to allow connection.
Fit a small piece of angle on the outer side of that wall just to support the assly. It tends to sag down a bit.
This set up works a treat.
If you want pics send me your email address.
Grrr!!!
FollowupID:
465950