Nissan 4.5lt valve clearances
Submitted: Saturday, Dec 09, 2006 at 17:31
ThreadID:
40207
Views:
2626
Replies:
2
FollowUps:
4
This Thread has been Archived
peter
Hi all and a Merry Xmas,
I am after the tappet clearances ( inlet and exhaust valves) for my GU 4.5lt Patrol as I would like to check / adjust the clearances.
Info on this would be greatly appreciated.
Have a good Xmas
Peter.
Reply By: donks1 - Saturday, Dec 09, 2006 at 20:13
Saturday, Dec 09, 2006 at 20:13
sorry peter, can't remember off hand..( don't do many petrols)
re post on monday to remind me and i'll get it for you
donks
AnswerID:
209506
Follow Up By: peter - Monday, Dec 11, 2006 at 22:26
Monday, Dec 11, 2006 at 22:26
Thanks Donks for replying to my post, info appreciated.
Peter.
FollowupID:
469915
Follow Up By: peter - Monday, Dec 11, 2006 at 22:41
Monday, Dec 11, 2006 at 22:41
Hi Donks,Peter again,could you confirm clearances for me,I have been informed clearances are .20 cold and .38 hot should this be the other way round .38 cold and .20 hot to allow for heat expansion when adjusting clearances when engine is cold so valves don't ride.
Thanks Peter.
FollowupID:
469919
Follow Up By: donks1 - Wednesday, Dec 13, 2006 at 15:57
Wednesday, Dec 13, 2006 at 15:57
hi peter
15thou by the book
FollowupID:
470171
Reply By: Member - Phil G (SA) - Sunday, Dec 10, 2006 at 10:33
Sunday, Dec 10, 2006 at 10:33
From
post 38670
TB45S Engine
Exhaust and intake 0.20mm Cold, 0.38mm hot
AnswerID:
209572
Follow Up By: peter - Monday, Dec 11, 2006 at 22:28
Monday, Dec 11, 2006 at 22:28
Thanks Phil for the info.
Peter.
FollowupID:
469916