MQ Patrol
Submitted: Monday, Feb 12, 2007 at 19:13
ThreadID:
42233
Views:
1446
Replies:
2
FollowUps:
4
This Thread has been Archived
growler
Does anyone know if it is possible to take motor and gear box out in one piece or do i have to split them,some of you old fellas must remember 1983 LOL
Thank you Graeme
Reply By: Stu-k - Monday, Feb 12, 2007 at 19:29
Monday, Feb 12, 2007 at 19:29
Ya should be right getting it out in one bit, but it wont fit in your wheelie bin that way!
AnswerID:
221281
Follow Up By: growler - Monday, Feb 12, 2007 at 19:44
Monday, Feb 12, 2007 at 19:44
Would that be yes or no or you dont no
FollowupID:
482015
Follow Up By: Stu-k - Monday, Feb 12, 2007 at 20:10
Monday, Feb 12, 2007 at 20:10
MQ dunno but done cruisers of that era(and later and a beep load of cars) with no probs.
Can`t see it being a prob just put it up on ramps to get a better swing angle.
FollowupID:
482026
Follow Up By: growler - Monday, Feb 12, 2007 at 20:32
Monday, Feb 12, 2007 at 20:32
Ta mate mate thanks
FollowupID:
482032
Reply By: Member - andrew B (Kununurra) - Monday, Feb 12, 2007 at 23:21
Monday, Feb 12, 2007 at 23:21
Gday Graeme
It wasn't much of an issue to split them when I had an MQ - so much so that I took the motor out to change the clutch rather than get under and muck around with jacks etc to get the box out......however on the GU i hate doing anything from the top - wires and hoses etc going everywhere....
Have fun.....what is going in to replace it
Cheers Andrew
AnswerID:
221334
Follow Up By: growler - Tuesday, Feb 13, 2007 at 19:32
Tuesday, Feb 13, 2007 at 19:32
Standard SD33 Andrew,rolled my old one awhile back.Motor has only done 10,000 klicks since complete rebuild,so have a rolling chassis to put my motor in,just wonderin the easiest way to do it
FollowupID:
482229