Trailer Hitch
Submitted: Thursday, Jun 21, 2007 at 23:37
ThreadID:
46946
Views:
2339
Replies:
3
FollowUps:
0
This Thread has been Archived
chardthechippy
I want to change to a rubber block and am wondering if a 50mm ball hitch over rider can be changed without replacing the whole over rider plunger.
It looks like the front of the plunger has a pin that might knock out the hitch but a bit unsure.
Reply By: Member - MrBitchi (QLD) - Friday, Jun 22, 2007 at 07:46
Friday, Jun 22, 2007 at 07:46
Think you need to change the whole thing. Don't think you can buy the bits seperately.
AnswerID:
248403
Reply By: traveller2 - Friday, Jun 22, 2007 at 11:46
Friday, Jun 22, 2007 at 11:46
Carter Wesco make the bits and you can change the centre bit as the casting is standard, just has to be the same brand.
AnswerID:
248444
Reply By: Member - Phil G (SA) - Friday, Jun 22, 2007 at 14:25
Friday, Jun 22, 2007 at 14:25
Chard,
The Treg hitch is made in
Adelaide (I think you're in
Adelaide??). Take it down to Tregs at Underdale, and they will sort it out.
AnswerID:
248471