ARB DIFF LOCK MISPLACED THE INSTRUCTION
Submitted: Saturday, Oct 20, 2007 at 19:21
ThreadID:
50723
Views:
2139
Replies:
1
FollowUps:
1
This Thread has been Archived
Member - Wayne B (QLD)
I posted a thread previously and I cannot locate the response I saved I am hoping the answer is still out there. On my ARB dif locks ARB installed the front cannot be engaged independently, only with rear locked in, got myself into a situation last weekend that really only needed the front. I need to know what I have to do to wiring to enable the selection of front only.
Kind Regards
Anyone in
Brisbane keen on doing a catch up 3rd November at Landcruiser or beach run up Double Island, will post also in gathering
Reply By: Member - Tim - Stratford (VIC) - Saturday, Oct 20, 2007 at 20:05
Saturday, Oct 20, 2007 at 20:05
Wayne,
I reckon if you jump the red wire from the rear switch to the same position on the front switch (where the yellow wire is) you should be right to activate either diff-lock. It should be still isolated until the compressor is switched on.
No responsibility accepted :-)
PM me with your email and I can fwd the diagram.
Tim
AnswerID:
267571
Follow Up By: Member - Wayne B (QLD) - Saturday, Oct 20, 2007 at 20:17
Saturday, Oct 20, 2007 at 20:17
Thanks Tim will try and let you know, no responsibility accepted if I do it then
well so be it
nice pics on your home page by the way
FollowupID:
529957