Landcruiser 100 series recall - wiring harness
Submitted: Tuesday, Jun 10, 2008 at 18:05
ThreadID:
58606
Views:
5535
Replies:
4
FollowUps:
1
This Thread has been Archived
Mikee5 (Logan QLD)
Just got a recall notice from Mr Toyota for my HZJ105:
There is a possibility that the dash board wire harness may be abnormally twisted changing its intended routing in the vehicle allowing contact with the unprotected edge of the pedal support bracket. If the vehicle is continuously driven on corrugated roads in this condition, the wire harness will rub against the pedal support bracket damaging the wire insulation cover resulting in a short circuit and blown fuse. In the worst case, the AM2 fuse blows and the engine stalls and/or may not start.
The labour time is approximately 1.0 hours.
Reply By: Trekkie (Member - WA) - Tuesday, Jun 10, 2008 at 18:23
Reply By: CraigB - Tuesday, Jun 10, 2008 at 19:36
Tuesday, Jun 10, 2008 at 19:36
Not just HZ105's. Mines the V8 and I have just received the notice as
well.
CraigB
AnswerID:
309075
Reply By: Richard W (NSW) - Tuesday, Jun 10, 2008 at 22:55
Tuesday, Jun 10, 2008 at 22:55
Mines in for the fix tomorrow.
AnswerID:
309137
Reply By: Member - Ruth D (QLD) - Wednesday, Jun 11, 2008 at 07:06
Wednesday, Jun 11, 2008 at 07:06
Bummer - that means we'll have to go to
Mount Isa (700 klms) for a fix then - oh dear, I'll have to force myself to go (hairdresser, dentist) shopping at K-Martini, good coffee, delicious food. Wonder when our notice will turn up - probably coming via slow pelican mail at the moment. Thanks for telling us Mikee.
AnswerID:
309160
Follow Up By: MADOG - Thursday, Jun 12, 2008 at 22:28
Thursday, Jun 12, 2008 at 22:28
Happened to me 147 k's north of
Tennant Creek last September.
Tennant Creek Toyota said I was #8. Quick fix - cable tie wiring up and away from brake pedal.
FollowupID:
575565