Little Bulldog Trailer Instructions

I've got a little bulldog over in the shed. Cant remember if they came with instructions but they are dead easy to 'erect'. Just spread the wheels a little, hinge open the draw bar, slide in the extension and winch, bolt on the cross member and away you go. You can then attach the guards and lights if needed and total set up used to take me about 5 minutes. I haven't used it for about 6-7 years and no longer need it. Should sell it.

Hi Leonardus,

I'll see if I can help by explaning

- undo the two nuts and remove tail light and number plate
bracket

- pull the two pins out that hold the cross bar to the top of the upright square tubes

- and lay the upright square tubes down into the U shaped holders and put the pins back in to hold them. (these square tubes stop the wheel frames from folding back when in use)

- undo the two nuts that hold the cross bar and remove cross bar

- undo two of the draw bar bolts and slide the front half of the draw bar (& winch post) out.

- fold the wheel/frames back towards the back roller until they fit neatly against the frame

After reading this I think I have even confused myself , I hope you have better luck.


Image Could Not Be FoundImage Could Not Be FoundImage Could Not Be Found