Hydrolic winch service/repair
Submitted: Monday, Mar 22, 2010 at 09:46
ThreadID:
77081
Views:
3088
Replies:
3
FollowUps:
4
This Thread has been Archived
Steve63
Hi
Have done a search with no joy. Wondering if anyone can recommend somewhere in
Adelaide to get an Ox Hydraulic winch serviced or know what my problem may be. I have looked at all the usual suspects ie electics. I have cleaned all the usual contacts up and have power in all the right spots but still no joy. It is though the solinoids will not engage.
Steve
Reply By: Member - Fred B (NT) - Monday, Mar 22, 2010 at 12:35
Monday, Mar 22, 2010 at 12:35
Try this:
TJM - Serious 4WD Equipment > Products > Products Parent >
Winches
All TJM OX Recovery
Winches come with TJMs Australia Wide 2 Year Warranty, with the Hydraulic Winch having 5 Years on the hydraulic motor and with TJMs ...
TJM OX Hydraulic Winch
AnswerID:
409897
Follow Up By: Steve63 - Tuesday, Mar 23, 2010 at 08:51
Tuesday, Mar 23, 2010 at 08:51
Yes is over 5 years. I could take it back to TJM.
Steve
FollowupID:
679947
Reply By: Member - Stuart P (WA) - Monday, Mar 22, 2010 at 17:24
Monday, Mar 22, 2010 at 17:24
recheck the earth connection/s
AnswerID:
409929
Follow Up By: Steve63 - Tuesday, Mar 23, 2010 at 08:51
Tuesday, Mar 23, 2010 at 08:51
Thanks will have another look at the earthing.
Steve
FollowupID:
679946
Reply By: burnsy - Monday, Mar 22, 2010 at 19:47
Monday, Mar 22, 2010 at 19:47
Send me a email pfpmike@bigpond.net.au
I will walk you through some diagnostic procedures.
First we need to narrow it down to electrical,hydraulic or mechanical.
Regards Mike
AnswerID:
409947
Follow Up By: Steve63 - Tuesday, Mar 23, 2010 at 09:32
Tuesday, Mar 23, 2010 at 09:32
Thanks, that would be helpful. Email already sent.
Steve
FollowupID:
679953
Follow Up By: Steve63 - Wednesday, Mar 24, 2010 at 09:17
Wednesday, Mar 24, 2010 at 09:17
For information there were two seperate issues. The isolator block did not always conduct. When I put the meter on it the pins were spread a bit and it conducted. With no preasure it did not conduct. One of the connectors to
the block had corroded and only condudted intermittently. Works fine again now. Big thanks to Mike for his assistance.
Steve
FollowupID:
680065