Wednesday, May 09, 2012 at 13:32
I agree with GTC about Long
Ranger's reputation. When they say "140 litres" I would confidently believe that is the liquid fuel capacity from a bone-dry tank to full. Trying to determine the tank capacity by calculating from driving and consumption is very inaccurate.
Rcam, if you really want to verify the tank liquid capacity you would need to drain the tank via the drain-plug then accurately measure the quantity of fuel to fill the tank. Whilst doing this you would also be able to determine how much fuel is required to extinguish the low-fuel lamp and also the gauge indications as the tank is filled.
In my own case as a
test, I continued to drive after the low-fuel lamp came on until the engine starved. This was about 50km so I now know how much reserve I have below "empty" indication.
In the other direction, with an absolutely full tank I drive about 100km before the gauge starts to move down from the top stop which is satisfactory. The overall calibration is therefore fairly reasonable but I believe it more important to have the gauge and lamp most accurate at the lower end.
Incidentally, it was necessary to have an automotive engineer verify and issue a vehicle modification plate for the tank installation. I understand that it was his requirement that the tank be filled with fuel as part of his inspection. I would expect that Long
Ranger would also specify this as part of the installation. If, as in my case, this were done the fuel fill would verify the tank capacity.
FollowupID:
760607