toyota 2lt

Submitted: Tuesday, Jun 07, 2005 at 21:21
ThreadID: 23671 Views:1504 Replies:2 FollowUps:0
This Thread has been Archived
Can anyone give me ideas as to what would course no.2 welsh plug on a newly rebulid 2lt surf motor to blow out????
Back Expand Un-Read 0 Moderator

Reply By: Sand Man (SA) - Tuesday, Jun 07, 2005 at 21:54

Tuesday, Jun 07, 2005 at 21:54
Quite simple.....It wasn't "pressed" in properly in the first place.
They are an interference fit.

Slight bit of water pressure and you soon know of any weak point.
Bill


I'm diagonally parked in a parallel Universe!

Member
My Profile  My Blog  My Position  Send Message

AnswerID: 114830

Reply By: bushy04 - Wednesday, Jun 08, 2005 at 09:08

Wednesday, Jun 08, 2005 at 09:08
Inncorect fitting of the welsh plug is the main one, however you may have a cracked head that has pressurised the system.

Tip. when you re fit the plus use No4 Permatex and you should not have any problems
AnswerID: 114859

Sponsored Links